31 35 Anti-roll bar
WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUE SPECIFICATIONS - ANTI-ROLL BAR
| Type | Thread | Tightening specifications | Dimension | |
|---|---|---|---|---|
| 1AZ Retaining bar for stabiliser to front axle carrier/steering gear | F01 / F02 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18 | M12 | Replace screw. | |
| Jointing torque | 100 Nm | |||
| Angle of rotation | 105 ° | |||
| F03 | M12 | Replace screw. | ||
| Jointing torque | 100 Nm | |||
| F03 | M14 | Replace screw. | ||
| Jointing torque | 165 Nm | |||
| F25 | M10 | 56 Nm | ||
| 2AZ Stabiliser link to stabiliser / damper | F01 / F02 / F03 / F04 / F06 / F07 / F10 / F11 / F12 / F13 / F18 | M12 | Replace nuts. | |
| Jointing torque | 45 Nm | |||
| Angle of rotation | 45° | |||
| 3AZ Anti-roll bar link to anti-roll bar | F25 | M12 | Replace nut. | 100 Nm |
| 4AZ Anti-roll bar link to damper | F25 | M12 | Replace nut. | 108 Nm |