33-4400 Device

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

0493416 334400 Device MW

NOTE: For removing inner wheel bearing race on rear axle [Released]

SI number

01 05 99 (426)

Consisting of:

3 = 0493818 Wrench

Fig 1: Identifying Device (0493416)

NOTE: (Ignition key) Discontinued, only available via complete tool [cannot be ordered individually]
4 = 0493819 Wrench
NOTE: (Ignition key) Discontinued, only available via complete tool [cannot be ordered individually]
1 = 0493816 Basic body
NOTE: No longer available separately, only available as part of complete tool set 0493416 = 33 4 400. [Not available separately]
2 = 0493817 Spindle
NOTE: No longer available separately, only available as part of complete tool set 0493416 = 33 4 400. [Not available separately]
5 = 0493820 Pliers
NOTE: (Clamping ring (45 to 51 mm)) No longer available separately, only available as part of complete tool set 0493416 = 33 4 400. [Not available separately]
6 = 0493821 Pliers
NOTE: (Clamping ring (50 to 55 mm)) No longer available separately, only available as part of complete tool set 0493416 = 33 4 400. [Not available separately]
7 = 0494617 Pliers
NOTE: (clamping ring (55...61 mm)) Model series: E67 No longer available separately, only via complete tool set 0493416 = 33 4 400. [Not available separately]
9 = 0496539 Synchronising key
NOTE: Series: F01, F02 See SI: 01 18 08 (482) Remaining inventories will be sold off and then it will no longer be available separately, only available as part of complete tool set 0493416 = 33 4 400. [Not available separately]
8 = 0496538 Ring
NOTE: (Clamping ring) Model series: F01, F02 See SI: 01 18 08 (482) [Released]