31-1000 Device

WARNING: This page is about a different car, the 2013 BMW 550i GT, 2012 BMW 550i GT, 2011 BMW 550i GT, and 2010 BMW 550i GT. However, it is still accessible from the selected car via links, so may be relevant.

0491850 311000 Device MW

NOTE: For removing and installing the rubber mount in the front axle support and in the wishbones and for press-fitting the taper roller bearing onto the differential case of the rear axle differential. [Discontinued]

Storage Location

Fig 1: Identifying Device (0491850)

Courtesy of BMW OF NORTH AMERICA, INC.

Consisting of:

= 0491851 Spindle
NOTE: With 2 nuts and 2 window glasses [discontinued]
= 0491852 Bush
NOTE: (Slip bush) For installing the rubber mount in the front axle support [discontinued]
= 0491853 Bush
NOTE: (Bush) For removing the rubber mount in the front axle support and for removing and installing the rubber mount in the wishbones and for press-fitting the taper roller bearing of the rear axle differential [discontinued]
= 0491854 Pipe
NOTE: (Support tube) For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491855 Washer
NOTE: (Flanged washer) For centring of threaded spindle and as a support disc for removing and installing the rubber mount in the front axle support and in the wishbones, series: E12 [discontinued]
= 0491856 Synchronising key
NOTE: For removing and installing rubber mount in front axle support, series: E12 [discontinued]
= 0491857 Bush
NOTE: For installing the rubber mount in the front axle support, series: E12 [discontinued]
= 0491858 Bush
NOTE: (Bush) For installing the rubber mount in the front axle support and thrust piece, for removing and installing the rubber mount in the wishbones [discontinued]
= 0491859 Bush
NOTE: (Bush) Discontinued, only available via complete tool [cannot be ordered individually]