LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 284 (Automatic Transmission - Operating Fluids) >> 5.0 Transmission Fluid Change Intervals (If Applicable) >> Condition Based Service (applies to certain vehicles only) - service bulletin SI B 00 07 02 (2/2009) >> Procedure To View Or Reset Service Items In The Instrument Cluster (Except The E65 And E66

Procedure To View Or Reset Service Items In The Instrument Cluster (Except The E65 And E66

WARNING: This page does not describe the selected car, but rather 158 other vehicles, including the 2014 BMW i8, 2014 BMW i3, 2014 BMW X6 M, 2014 BMW X6, and 2014 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition to Terminal 15.
  2. Press and hold the Instrument Cluster Set/Reset button for 10 seconds.
  3. The upper display in the Instrument Cluster will be illuminated with a Service Item (example: An oil can is the designation for Oil Service). The lower display in the Instrument Cluster will indicate the remaining time or mileage left for that Service Item (example: 14000). Pressing the button repeatedly will allow the display to scroll through all of the Condition Based Service Items.
  4. Press and hold the Instrument Cluster Set/Reset button again and the lower display screen will indicate "OK" or "DUE".
  5. Pressing the Instrument Cluster Set/Reset button again will allow the "RESET" to appear in the lower window for that service. Releasing and reapplying the button one more time will reset the service displayed in the upper window only. Repeat the procedure for any additional service reset needs.
NOTE: The CBS service items for both State Vehicle Safety Inspection and State Emissions Inspection cannot be viewed in the Instrument Cluster. These State Inspections can be viewed on the CBS Menu in the Control Display or by DISplus / GT1.
scientia non olet · About LEMON Manuals