17 51 020 Removing and installing or replacing auxiliary water pump for charge air cooler (N63)

WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2015 BMW Alpina B7L, 2015 BMW Alpina B7, 2015 BMW 750i, 2015 BMW 750Li, and 2015 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Check stored fault message
Switch off ignition
Remove FAN COWL .
Drain coolant for charge air cooler

Unlock connector (1) and remove.

Unlock and detach coolant hose (2).

Release clamp (3) and detach coolant hose.

Release screw (4).

Remove auxiliary water pump.

Fig 1: Identifying Coolant Hose, Connector, Clamp And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

After completing repair work, top charge air cooler up with coolant.

Vent COOLING SYSTEM FOR CHARGE AIR COOLER .

Check cooling system for tightness.

Assemble engine.

Read out the fault memory of the DME control unit.

Clear diagnostic fault entries from fault memory.