11 61 065 Removing and Installing/Replacing Left Intake Plenum (N63O1)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary Preliminary Tasks:

Remove The Engine with FRONT AXLE .
Remove Left THROTTLE VALVE .

Disconnect Plug Connection (1) At Servomotor for Eccentric Shaft (2).

Fig 1: Identifying Plug Connection and Eccentric Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Wiring Harness From Clamps (1).

Disconnect Plug Connection (2).

Release Screws (3).

Tightening torque: 13 62 2AZ .

Remove Pressure Sensor (4).

Installation Note:

Replace O-Ring.

Fig 2: Identifying Pressure Sensor, Plug Connection, Clamps and Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew Nuts (1).

Tightening torque: 11 61 1 AZ .

Remove Intake Plenum (2).

Fig 3: Identifying Intake Plenum and Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation Note:

Replace All Sealing Rings (1).

Observe Mounting Pin On The Differentiated Air Intake System.

Fig 4: Identifying Sealing Ring and Mounting Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine and Vehicle.

Check Air Intake System for Leaks with Diagnosis System.

DME.
Air Supply.
Charging Pressure Control.
(ATL) Exhaust Turbocharger Procedure.