11 00 670 Securing the engine in the installation position (N55 Hybrid)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 6 000
00 6 002
00 6 004
00 6 010
00 6 050
00 6 050.

WARNING:

High-voltage hazard!

The following must be strictly observed prior to starting work :

Observe SAFETY INFORMATION for handling hybrid cars.

WARNING: Danger of injury.
Observe following instructions relating to special tool:

Prior to each use, check the special tools for defects, modifications and operational reliability.
Damaged/modified special tools must not be used.
No changes or modifications may be made to the special tools.
Keep special tools dry, clean and free of grease.

IMPORTANT: Before lifting the engine, check the lifting lugs for damage (cracks) and to ensure they are seated securely.

NOTE:

Numbering system for special tools has been re-encoded.

IMPORTANT: Special tool must not be fitted when cross-member (1) is installed.

Fig 1: Identifying Cross-Member

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

SECURING ENGINE COMPARTMENT LID IN SERVICE POSITION .
REMOVING UNDERBODY PROTECTION AT FRONT AND REAR .
Remove TRIM PANEL for engine compartment lid at side
Remove acoustic cover

Assemble transverse member 00 6 000 with special tools 00 6 002 00 6 004, 00 6 010, 00 6 050.

Fig 2: Assembling Cross-Member 00 6 000 With Special Tools 00 6 002 00 6 004, 00 6 010, 00 6 050

Courtesy of BMW OF NORTH AMERICA, INC.

Fig 3: Identifying Special Tools (Crossmember 00 6 100, Adapters 00 6 130, T-Pieces 2 318 635, And Supports 00 6 050)

Courtesy of BMW OF NORTH AMERICA, INC.

New tool.

Assemble traverse member with special tool 00 6 050.

Graphic shows: N63 engine

NOTE: Contact points (1) for special tool 00 6 050. are pictured.

Position transverse member with a 2nd person helping on contact points (1).

Fig 4: Identifying Contact Points

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Before lifting the engine, check the lifting lugs for damage (cracks) and to ensure they are seated securely.

Screw towing hook (1) into engine block.

Align cross-member so that spindle is correctly positioned over towing hook.

Secure chain to the spindle and suspend from towing hook (1).

WARNING: Danger of injury.
Tighten down all screws and nuts on transverse member.

Fig 5: Identifying Towing Hook

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Avoid a change of engine position in the transverse or longitudinal direction.
Always make sure there is sufficient clearance between the engine (or its add-on parts) and the body.

Release bolts (1) on engine mount.

Raise engine approx. 10 mm with cross member.

IMPORTANT: Observe installation note.
To ensure play between engine mount and engine support arm, lower the engine completely before tightening the screw connection (engine mount/engine support arm).
Tightening torque 22 11 2AZ .

Fig 6: Identifying Engine Mount Bolt

Courtesy of BMW OF NORTH AMERICA, INC.