11 12 040 Removing and installing all ignition coil and injector wells (N55 Hybrid)
WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
High-voltage hazard!
The following must be strictly observed prior to starting work :
- Observe SAFETY INFORMATION for handling hybrid cars.
Necessary preliminary work:
- Remove CYLINDER HEAD COVER .
- REMOVE all injectors.
Release screws (1).
Tightening torque: 11 12 8AZ .
Check fitting bushes (1) for damage.
Installation note:
Replace gasket (2).
Assemble engine.