LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M6 2D Convertible, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Functional Description - F10 - Engine Performance) >> Engine Performance - Functional Description >> Vacuum unit for turbine control flap >> Check

Vacuum unit for turbine control flap: Check

WARNING: This page does not describe the selected car, but rather 45 other vehicles, including the 2016 BMW M5, 2016 BMW 550i xDrive, 2016 BMW 550i, 2016 BMW 535i xDrive, and 2016 BMW 535i. However, it is still accessible from the selected car via links, so may be relevant.

The turbine control flap vacuum unit can be checked as follows:

  1. Pull off the vacuum hose from the vacuum unit.
  2. Connect the vacuum pump to the vacuum unit.
  3. Establish vacuum pressure at 500 mbar using the vacuum pump.
  4. If the vacuum unit does not  hold the vacuum: Renew  the vacuum unit.
  5. If the vacuum unit holds the vacuum: Continue with point 6.
  6. Pull the linkage in the direction of arrow. If the linkage can be pulled out in the direction of arrow without any resistance: Renew  the vacuum unit.
scientia non olet · About LEMON Manuals