13 71 030 Removing and installing/replacing both intake silencer housings (S63 B44 T 0)

Necessary preliminary tasks:

NOTE: Description relates to the left intake silencer housing, the procedure for the right side is identical.

Release clamp (1).

Tightening torque 13 71 2AZ .

Disconnect connector (2) at the hot film air mass meter.

Release screw (3).

Tightening torque 13 71 1AZ .

Fig 1: Identifying Intake Silencer Housing, Connector, Clamp And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release hose (4) from intake silencer housing.

Pull off intake silencer housing (5) to the top out of rubber mount and remove.