11 65 010 Removing and installing/replacing vacuum reservoir (S63)

Necessary preliminary tasks: 

• Remove STIFFENING PLATE .
• Lower FRONT AXLE SUPPORT .

Release vacuum line (1).

Unfasten screws (2).

Tightening torque: 11 65 10AZ .

Unclip vacuum line from holder (3).

Remove vacuum reservoir (4).

Fig 1: Identifying Vacuum Reservoir, Vacuum Line, Holder, And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Check vacuum connections.

Observe BMW diagnosis instructions.

1. Complete vehicle
2. Electric motor
3. Engine electrical system
4. Air supply
5. Charging pressure control