17 00 009 Checking Cooling System For Watertightness (N55, N63, N47 D20 O/T 1, N57 D30 U/O/T/S 0/1)

Special tools required:

WARNING: Risk of scalding!
Only perform this repair work after engine has cooled down.

Protective measures/rules of conduct:

Wear safety goggles.
Wear protective gloves.
Observe national/country-specific regulations.

IMPORTANT: Risk of skidding due to coolant on the floor.
Danger of injury!

Catch and dispose of drained coolant in drip tray (1) and if necessary special tool 00 2 030 (universal hydraulic lifting equipment).

Recycling:

Observe country-specific waste disposal regulations.

Fig 1: Supporting Coolant Drip Tray Using Special Tool (00 2 030)

Courtesy of BMW OF NORTH AMERICA, INC.

Checking pressure drop in cooling system:

Open the sealing cap on the coolant expansion tank. Mount special tool (1) 17 0 101 and (2) 17 0 113 from the set of special tools 17 0 100 .

Build up excess pressure and wait approx. 2 minutes. See N57 RADIATOR WITH MOUNTING, BMW, F06, F10, F11, F12, F13, N57 D30 U/O/T/S 0/1 , N55 RADIATOR WITH MOUNTING, BMW, F01, F02, F06, F10, F11, F18, F12, F13 or N63 RADIATOR WITH MOUNTING, BMW, F06, F07, F10, F11, F12, F13, N63 B40/B44 O 0/1

Cooling system is impervious to watertightness if pressure drop is max. 0.1 bar.

Fig 2: Checking Pressure Drop In Cooling System

Courtesy of BMW OF NORTH AMERICA, INC.

Checking pressure relief valve in sealing cap:

NOTE: While the driving at high ambient temperatures, the design may cause the pressure relief valve in the sealing cap to open slightly and air together with dissolved coolant to escape. This coolant vapor condenses on the surface of the expansion tank and leaves traces when the vehicle has cooled down. These toes do not indicate whether the sealing cap is defective or not. When the vehicle has been parked up for an extended period of time, the residual escaping coolant can cause the pressure relief valve in the sealing cap to stick; therefore check the sealing cap again 2 to 3 times.

Replace the sealing cap only after you have checked three times and there is an incorrect opening pressure .

Checking pressure relief valve in sealing cap:

Screw on sealing cap (1) to special tool 17 0 114.

Build up pressure with special tool (hand pump) 17 0 101; observe pressure gauge to ascertain when opening pressure is achieved.

Compare opening pressure of pressure relief valve. See N57 RADIATOR WITH MOUNTING, BMW, F06, F10, F11, F12, F13, N57 D30 U/O/T/S 0/1 , N55 RADIATOR WITH MOUNTING, BMW, F01, F02, F06, F10, F11, F18, F12, F13 or N63 RADIATOR WITH MOUNTING, BMW, F06, F07, F10, F11, F12, F13, N63 B40/B44 O 0/1 .

Fig 3: Checking Pressure Relief Valve In Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.