11 31 090 Installing and removing/replacing chain tensioner piston (N20)

Release screws (1).

Tightening torque: 11 65 4AZ .

Fig 1: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Raise vacuum unit (1) slightly.

Release chain tensioner (2).

Tightening torque 11 31 7AZ .

IMPORTANT: Have a cleaning cloth ready. A small quantity of engine oil will escape after the screw connection has been released.
Make sure no engine oil runs onto belt drive.

Installation note:

Replace sealing ring.

Fig 2: Identifying Vacuum Unit And Chain Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

If the chain tensioner is reused, its oil chamber must be drained.

Place chain tensioner on a level support and slowly compress.

Repeat process twice.

Fig 3: Draining Oil Chamber Of Chain Tensioner

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Installation note:

BLEEDING INSTRUCTION must be observed without fail.