LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2014 >> M5 Automatic DCT Trans >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head & Flywheel - Repair >> Cylinder Head >> N52 Engine >> 11 12 251 Removing and installing/replacing gasket for eccentric shaft sensor (N52)

11 12 251 Removing and installing/replacing gasket for eccentric shaft sensor (N52)

Special tools required: 

Necessary preliminary tasks: 

Removal: 

Unlock and disconnect the connector (1).

Fig 1: Identifying Connector
G09919435Courtesy of BMW OF NORTH AMERICA, INC.

Lift gasket (1) using a suitable tool.

Fig 2: Lifting Gasket Using Suitable Tool
G09919436Courtesy of BMW OF NORTH AMERICA, INC.

Lift out gasket (1) using a plastic tool.

Fig 3: Lifting Out Gasket
G09919437Courtesy of BMW OF NORTH AMERICA, INC.

Remove eccentric shaft sensor gasket (1).

Fig 4: Removing Eccentric Shaft Sensor Gasket
G09919438Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Insert gasket.

Installation note: 

Coat sealing surfaces lightly with engine oil.

Fig 5: Inserting Gasket
G09919439Courtesy of BMW OF NORTH AMERICA, INC.

Press in gasket (1) with special tool 11 6 420 .

Fig 6: Pressing Gasket Using Special Tool
G09919440Courtesy of BMW OF NORTH AMERICA, INC.

Connect the plug (1).

Fig 7: Identifying Connector
G09919441Courtesy of BMW OF NORTH AMERICA, INC.

Required follow-up work: 

scientia non olet · About LEMON Manuals