51 47 030 Removing and installing/replacing (inside) rear left or right entrance cover strip
Special tools required:
When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.
Necessary preliminary tasks:
With basic seat:
- Partially remove BACKREST .
With SA through-loading system:
- Remove ARMREST SIDE SECTION
- Partially remove REAR SEAT
Detach plastic rivet (2) from entrance cover strip (1).
Carefully lever off entrance cover strip (1) with special tool 00 9 325 starting in the center, then in the front and rear and remove it outwards to the rear.
Installation:
Correctly hook entrance cover strip (1) into liner for lower door column (3) with retaining tabs (4).
Installation:
Replace faulty clips (1).
Replacement
Modify clips (1).