51 43 201 Removing and installing or replacing trim for roof pillar at front (A-pillar), left or right

WARNING: Follow SAFETY INSTRUCTIONS for working on vehicles with airbag systems.

IMPORTANT: Do not use any sharp-edged tools to remove trim (risk of damage to head airbag).

Detach edge protection (1) in area of trim panel (2).

Detach trim panel (2) from the first detent position of the clamp (4) toward the inside.

Loosen the trim panel (2) toward the top and thereby detach it from the clips (3).

Feed out trim panel (2) from dashboard and remove.

Installation note:

Fig 1: Detaching Trim Panel Edge Protection

Courtesy of BMW OF NORTH AMERICA, INC.

Make sure EDGE PROTECTION (1) is correctly seated.

Always replace clamps (4).

Installation note:

Always replace clamps (2).

Pry out any clips (1) remaining in the body and insert in cover

Replace faulty clips (1).

Make sure guides (3) is correctly seated in associated mounts.

Fig 2: Roof Pillar Clamps And Clips

Courtesy of BMW OF NORTH AMERICA, INC.