37 12 012 Carry out ride height adjustment
NOTE:
Ride height adjustment must be carried out after the following work:
- Removal/replacement of ride height sensor or its control rod (only necessary on vehicles with air suspension)
- Replacement of EHC control unit (F01/F02/F04/F07/F11/F15/F16/F85/F86)
- Replacement of ICM control unit (Integrated Chassis Management)
Connect diagnosis system.
Switch the ignition on.
Carry out ride height adjustment (menu item: "Service function").
IMPORTANT:
Following ride height adjustment, for vehicles with:
- Run Flat Indicator: Initialize RUN FLAT INDICATOR .
- Tire Pressure Monitor: Perform TIRE PRESSURE CONTROL (RDC) RESET .