51 24 133 Removing and installing/replacing Automatic Soft Close drive on rear lid (Automatic Soft Closing)

Necessary preliminary work:

Disconnect plug connection (1).

Release screws (2) and feed out drive (3).

Tightening torque 51 24 4AZ .

Fig 1: Identifying Plug Connection And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Feed Bowden cable out of REAR LID LOCK .

Installation note:

Make sure Bowden cable (1) is correctly positioned in rear lid.

Lay Bowden cable (1) without kinks.

Fig 2: Identifying Bowden Cable

Courtesy of BMW OF NORTH AMERICA, INC.