51 12 050 Removing and installing/replacing support for rear bumper panel

Necessary preliminary work:

Lever out expander rivet (1) on adapter (2) and cover (3).

NOTE: Cover can vary.
The trailer tow hitch optional equipment is pictured.

Fig 1: Identifying Rivet, Adapter And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip adapter (1) on bumper panel (2) at marked points.

If necessary, unlock and disconnect plug connections on control unit for RDC or Smart Opener.

Fig 2: Locating Adapter On Bumper Panel Marked Points

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Operation is described on the left side.

Right side identical.

Unscrew nuts (1).

Tightening torque 51 12 1AZ .

Slacken nut (2).

Remove carrier (3).

Fig 3: Identifying Rear Bumper Trim And Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement: