51 23... Adjusting/replacing bump stops (2 of 4)

The illustrations are schematic representations and are to be applied to the relevant vehicle type.

Prerequisite: Lid must be correctly adjusted.

Following parts must not be damaged:

(1) Bump stop
(2) Catches

Remove stop pad by pressing latch mechanisms back.

Fig 1: Identifying Bump Stop And Catches

G06885609

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in stop pad (1) to create distance to front compartment lid.

Place a cone (2) of modeling or sealing compound on the stop pad.

Slowly close bonnet.

Fig 2: Adjusting Buffer And Cone

G06885610

Courtesy of BMW OF NORTH AMERICA, INC.

Raise bonnet.

Compressed cone (1) determines distance between stop pad and front compartment lid.

Fig 3: Identifying Cone

G06885611

Courtesy of BMW OF NORTH AMERICA, INC.

Measure dimension a between compressed cone and edge (1) of stop pad.

Fig 4: Measuring Dimension Between Compressed Cone And Edge Of Stop Pad

G06885612

Courtesy of BMW OF NORTH AMERICA, INC.

Adjust measured dimension a + 0.5 mm by unscrewing stop pad (1).

Fig 5: Adjusting Stop Pad Dimension

G06885613

Courtesy of BMW OF NORTH AMERICA, INC.