11 22 513 Replacing roller bearing for dual-mass flywheel (N55)
WARNING: This page does not describe the selected car, but rather 24 other vehicles, including the 2018 BMW 320i xDrive, 2018 BMW 320i, 2017 BMW 320i xDrive, 2017 BMW 320i, and 2016 BMW 335i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required:
NOTE:
Flywheel removed!
Using hydraulic press (1) and special tool 21 2 051 , press roller bearing out of dual-mass flywheel downwards on engine side.
IMPORTANT:
Risk of damage:
Roller bearing must not be driven out.
Roller bearing must not be driven out.
Push roller bearing (2) onto special tool 21 2 052 .
Using hydraulic press (1), press roller bearing into dual-mass flywheel to limit position on clutch side.
IMPORTANT:
Risk of damage:
Observe press-in instruction:
Observe press-in instruction:
- Roller bearing must not be driven in.
- Roller bearing mounting force/travel monitored:
Min. 2000 N 1 mm before end of pressing in.
Max. 15, 000 N during entire press-in procedure.