Installing luggage compartment floor, center, left and right

Clean all  bonding surfaces with cleaning agent R1.

Apply adhesive to bonding surfaces.

Install new parts and rivet with blind rivets.

Perform MAG welding throughout to new part in area (1).

Set 20 mm MAG welds at a distance of 15 mm in area (2).

Fig 1: Identifying MAG Welding Area And MAG Welds Area

Courtesy of BMW OF NORTH AMERICA, INC.

Weld new parts in area (5).

(1) to (4) = Adhesive riveted areas.

Fig 2: Identifying Weld Parts Area And Adhesive Riveted Areas

Courtesy of BMW OF NORTH AMERICA, INC.

After hardening of the adhesive install 4 EMC SCREWS  in the areas (1).

Fig 3: Identifying EMC Screws

Courtesy of BMW OF NORTH AMERICA, INC.