11 65 180 Removing and Installing/Replacing Heat Shield At Top (N63)

Necessary Preliminary Tasks:

Release Screws (1).

Lift Out Holder.

Fig 1: Identifying Holder Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release Screw (2).

Tightening torque 11 65 3AZ .

Fig 2: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release Screw (2).

Tightening torque 11 65 3AZ .

Fig 3: Identifying Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release Retaining Clip (1).

Detach Wire Ring (2) and Set Down Behind Oxygen Sensor.

Fig 4: Identifying Retaining Clip and Wire Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release Retaining Clip (1).

Detach Wire Ring (2) and Set Down Behind Oxygen Sensor.

Fig 5: Identifying Retaining Clip and Wire Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Release Screws (1).

Tightening torque 11 65 3AZ .

NOTE: for Purposes of Clarity, The Graphic Shows The Oxygen Sensor Removed.

Fig 6: Identifying Heat Shield Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release Screws (1).

Tightening torque 11 65 3AZ .

Lift Out Heat Shield.

Fig 7: Identifying Heat Shield Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.