11 12 729 Checking Cylinder Head On Watertightness (N63O1)

Special Tools Required:

Necessary Preliminary Tasks:

NOTE: Set of Special Tools 11 8 080 Can Be Used for Cylinder Bank 1 To 4 and Cylinder Bank 5 To 8.

Position Special Tool 11 8 081 On Cylinder Head.

Fig 1: Positioning Special Tool 11 8 081 On Cylinder Head

Courtesy of BMW OF NORTH AMERICA, INC.

Insert Special Tool 11 8 083 and Tighten In Sequence (1 To 10) In Several Steps.

Tightening torque: 25 Nm .

Graphic Shows Engine N63.

Fig 2: Cylinder Head Bolts Tightening/Loosening Sequence (N63O1)

Courtesy of BMW OF NORTH AMERICA, INC.

Remove Bleeder Screw (1).

Tightening torque: 11 12 7 AZ .

Installation Note:

Replace Sealing Ring.

Fig 3: Identifying Vent Screw

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Max: 0.8 Nm.

Screw In Special Tool 11 8 082 with Suitable Tool and Special Tool 00 9 250 To 0.8 Nm.

Connect Compressed Air Hose with Pressure Gauge.

Immerse Cylinder Head In A Water Bath. Test Pressure: 3.0 Bar.

Check Cylinder Head for Escaping Air (Cracks).

Fig 4: Installing Special Tool 11 8 082 Using Suitable Tool

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: If Necessary, Add Cleaning Agent To Water Bath.
Assemble Engine.