11 14 110 Removing and Installing Lower Timing Case Cover (N63)

Special Tools Required:

Necessary Preliminary Tasks:

Release Screws Along Lines (1).

Remove Timing Case Cover (2) Towards Front.

Clean Sealing Surfaces with Special Tool 11 4 470 .

Fig 1: Identifying Timing Case Cover and Screws

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check Jump Guard for Damage.

Release Screw (1).

Tightening torque 11 14 1AZ .

Remove Jump Guard (2).

Fig 2: Identifying Jump Guard and Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Clean Sealing Surfaces with Special Tool 11 4 470 .

Installation Note:

Preposition All Bolts In Timing Case Cover.

Replace Beaded Metal Gaskets (1, 2 and 3).

Fig 3: Identifying Beaded Metal Gaskets On Timing Case Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Fit Timing Case Cover (2).

Initially Tighten All Bolts To Approx. 5 Nm.

Fully Tighten All Bolts In Alternate Sequence.

Tightening torque 11 14 2AZ .

Installation Note:

Wait for Pu Material To Emerge At Sealing Joints.

Carefully Wipe Off Protruding Pu Material.

Fig 4: Identifying Timing Case Cover and Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Replace RADIAL SHAFT SEAL In Gear Case Cover At Bottom .

Assemble Engine.