11 14 015 Removing and Installing/Replacing Sealing Cap for Oil Pump Chain Tensioner (N55)

Special Tools Required:

Necessary Preliminary Tasks:

Drive Out Sealing Cap (1) with A Suitable Punch (2) In Direction of Arrow.

NOTE: The Sealing Cap Is Driven Out Diagonally During This Operation.

Fig 1: Driving-Out Sealing Cap Using Punch Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Removing Sealing Cap

Prepare Special Tool 11 8 530 .

Remove Special Tool 11 8 533 From Special Tool 11 8 532 and 11 8 534 .

Special Tool 11 8 536 Is Not Required.

Fig 2: Removing Sealing Cap

Courtesy of BMW OF NORTH AMERICA, INC.

Special Tool 2 318 118 Is Magnetic.

Secure Special Tool 2 318 118 On Special Tool 11 8 531 (Refer To Fig 3).

Fig 3: Securing Special Tool 2 318 118 On Special Tool 11 8 531

Courtesy of BMW OF NORTH AMERICA, INC.

Screw Back Screw (2) On Special Tool 2 318 119 .

Install Special Tool 2 318 119 with Screw (1) On Special Tool 11 8 531 .

Fig 4: Installing Special Tool 2 318 119 with Screw On Special Tool 11 8 531

Courtesy of BMW OF NORTH AMERICA, INC.

Position Sealing Cap (1) On Crankcase (2).

Fig 5: Positioning Sealing Cap On Crankcase

Courtesy of BMW OF NORTH AMERICA, INC.

Installing Sealing Cap

Screw In Screw (1) On Special Tool 2 318 119 Up To Limit Position.

Tightening torque 20 Nm.

Fig 6: Identifying Screw On Special Tool

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.