11 61 065 Removing and Installing/Replacing Left Intake Plenum (N63O1)

Necessary Preliminary Tasks:

Disconnect Plug Connection (1) At Servomotor for Eccentric Shaft (2).

Fig 1: Identifying Plug Connection and Eccentric Shaft

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip Wiring Harness From Clamps (1).

Disconnect Plug Connection (2).

Release Screws (3).

Tightening torque: 13 62 2AZ .

Remove Pressure Sensor (4).

Installation Note:

Replace O-Ring.

Fig 2: Identifying Pressure Sensor, Plug Connection, Clamps and Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew Nuts (1).

Tightening torque: 11 61 1 AZ .

Remove Intake Plenum (2).

Fig 3: Identifying Intake Plenum and Nuts

Courtesy of BMW OF NORTH AMERICA, INC.

Installation Note:

Replace All Sealing Rings (1).

Observe Mounting Pin On The Differentiated Air Intake System.

Fig 4: Identifying Sealing Ring and Mounting Pin

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine and Vehicle.

Check Air Intake System for Leaks with Diagnosis System.