11 22 513 Replacing Roller Bearing for Dual-Mass Flywheel (N63)

Special Tools Required:

NOTE: FLYWHEEL Removed!

Using Hydraulic Press (1) and Special Tool 21 2 051, Press Roller Bearing Out of Dual-Mass Flywheel Downwards On Engine Side.

IMPORTANT: Risk of Damage:
Roller Bearing Must Not Be Driven Out.

Fig 1: Pressing Roller Bearing Out of Dual-Mass Flywheel Using Hydraulic Press and Special Tool 21 2 051

Courtesy of BMW OF NORTH AMERICA, INC.

Push Roller Bearing (2) Onto Special Tool 21 2 052.

Using Hydraulic Press (1), Press Roller Bearing Into Dual-Mass Flywheel As Far As It Will Go On Clutch Side.

IMPORTANT: Risk of Damage:
Observe Press-In Instruction:

Roller Bearing Must Not Be Driven In.
Roller Bearing Mounting Force/Travel Monitored:
Min. 2000 N 1 Mm Before End of Pressing In.

Max. 15, 000 N During Entire Press-In Procedure.

Fig 2: Pressing Roller Bearing Into Dual-Mass Flywheel

Courtesy of BMW OF NORTH AMERICA, INC.