11 22 500 Removing and Installing/Replacing Flywheel (N55)
Special Tools Required:
IMPORTANT:
Aluminum Screws/Bolts Must Be Replaced Each Time They Are Released
.
Aluminum Screws/Bolts Are Permitted with and Without Color Coding (Blue).
for Reliable Identification:
Aluminum Screws/Bolts Are Not Magnetic .
Joining Torque and Angle of Rotation Must Be Observed Without Fail (Risk of Damage) .
Aluminum Screws/Bolts Are Permitted with and Without Color Coding (Blue).
for Reliable Identification:
Aluminum Screws/Bolts Are Not Magnetic .
Joining Torque and Angle of Rotation Must Be Observed Without Fail (Risk of Damage) .
Necessary Preliminary Tasks:
- Remove Gearbox. See TRANSMISSION (GA8HP45Z) or TRANSMISSION (GA8HP45Z) WITH AWD .
- Remove Clutch
Automatic Transmission
Secure Flywheel (1) with Special Tool 11 9 260 .
Unfasten Flywheel Bolts.
Tightening torque 11 22 1AZ .
Installation Note:
Flywheel (1) Is Secured with An Dowel Pin.
Manual Gearbox
Fasten Dual-Mass Flywheel with Special Tool 11 9 260 and 11 9 265 .
Release Flywheel Bolts with Special Tool 11 4 180 /
Tightening torque 11 22 2AZ .
Installation Note:
Fit New Flywheel Bolts.
Clean All Threads for Flywheel Bolts In Crankshaft.
Installation Note:
Pay Attention To Dowel Pin.
Installation Note:
Ensure Installed Position of Magnet Wheel Is Correct.
Assemble Engine.