11 13 010 Removing and Installing/Replacing Upper Oil Sump Section (N63O1)

Special Tools Required:

Necessary Preliminary Tasks:

Drain Off ENGINE OIL .
LOWERING FRONT AXLE .
Remove LOWER OIL SUMP SECTION .
Remove OIL PUMP .
Release Supply/Return Lines On Oil Filter
Release Holders of Supply/Return Lines On Oil Sump
Detach Plug From Oil Pressure Switch

Unclip Wiring Harness On Oil Sump

Release Oil Filter Cover (1) with Special Tool 11 9 240 .

Tightening torque 11 42 1AZ .

Graphic Without Reinforcement Plate.

Fig 1: Removing Oil Filter Cover Using Special Tool 11 9 240

Courtesy of BMW OF NORTH AMERICA, INC.

Remove Oil Filter (1).

Release Bolts In Area of Line (2).

Tightening torque 11 13 2AZ .

Fig 2: Identifying Oil Filter and Bolts

Courtesy of BMW OF NORTH AMERICA, INC.

Release Screws (1).

Release 4 Bolts On Transmission Side.

Graphic Without Transmission.

Installation Note:

Clean Gasket Debris From Sealing Surfaces with Special Tool 11 4 470 .

Replace Gasket.

Modify Oil Pressure Switch If Replacing Oil Sump.

Fig 3: Locating Bolts On Transmission Side

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.