11 14 250 Removing and Installing/Sealing Rear Coolant End Cover (N63)

Special Tools Required:

WARNING: Risk of Scalding!
Only Perform This Work After Engine Has Cooled Down.

Recycling

Catch and Dispose of Drained Coolant In A Suitable Collecting Vessel.

Observe Country-Specific Waste Disposal Regulations.

Necessary Preliminary Tasks:

Release All Screws In Area (1).

Tightening torque 11 14 5AZ .

Remove End Cover.

NOTE: Clean Sealing Surfaces with Special Tool 11 4 470 .

Fig 1: Locating Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation Note:

Replace Profile Seal (1).

Fig 2: Identifying Profile Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble Engine.