41 11 565 Replace Sill In Vicinity Of Left C-Pillar (Rear Side Panel Removed)

Read contents of BODY, GENERAL .

Use only approved SPOT-WELDING APPARATUS for repairs.

The following new body parts are required:

Entrance, rear (component is included on new side panel part)

Removing sill section

Mark severance cut in accordance with dimension and cut.

IMPORTANT: Cut outer panel only.

Dimension a = approx. 60 mm from center point of 20 mm dia. hole.

Open welded connections in areas (1) and (2).

(welded connection (2) = reinforcement of jacking point on inside sill)

Remove rear entrance (3).

Installation note:

When installing, replace welded connection (2) with BONDED CONNECTION .

Fig 1: Identifying Welded Connections Dimension

Courtesy of BMW OF NORTH AMERICA, INC.

Apply repair welding spots in area (1) to existing welding spots on new component/vehicle. This is necessary because the adhesive between the spot flanges acts as an insulator.

Weld in REINFORCEMENT PLATE at severance cut.

Preparation of new part

Open welded connections in area (1).

Remove sill section (2).

Fig 2: Identifying Sill Section And Welded Connections Area

Courtesy of BMW OF NORTH AMERICA, INC.

Mark severance cut (1) in accordance with vehicle and cut.

Do not grind/sand new part in area of bonding surfaces.

Fig 3: Identifying Severance Cut

Courtesy of BMW OF NORTH AMERICA, INC.

Installing sill section

Apply K5 ADHESIVE to bonding surfaces (1).

Install new part and reinforcement plate and weld in place.

Fig 4: Identifying K5 Adhesive To Bonding Surfaces

Courtesy of BMW OF NORTH AMERICA, INC.