51 13 061 Replacing wheel arch trim on front left or right side panel (Japanese national-market version)

IMPORTANT:

The NOTES on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

IMPORTANT:

For reasons of optimal adhesion, painting of bonding surfaces on the inside of the wheel arch trim is prohibited!
The application of the adhesive pad (double-sided adhesive tape) onto the wheel arch trim must therefore occur prior to painting the wheel arch trim!

(1) = Wheel arch trim

(2) = adhesive pad

Fig 1: Identifying Wheel Arch Trim And Adhesive Pad

Courtesy of BMW OF NORTH AMERICA, INC.

Removal:

Carefully heat the wheel arch trim (1) with a hot air blower (temperature approx. 40-55 °C) and pull off.

Fig 2: Identifying Wheel Arch Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Pull protective film off adhesive pad (double-sided adhesive tape).

Attach wheel arch trim (1) to side wall according to specified dimensions and press down firmly.

Measurement a = approx. 22 mm.

Measurement b = approx. 2, 9 mm

Fig 3: Identifying Wheel Arch Trim Dimension

Courtesy of BMW OF NORTH AMERICA, INC.