41 12 548 Replacing Rear Cross Member On Luggage Compartment Floor (Tail Panel Removed)

Read contents of BODY, GENERAL .

Observe procedure for REPAIR STAGE 2 .

Following new body parts are required (refer to BMW ELECTRONIC PARTS CATALOGUE ):

Following CONSUMABLES are required:

Fig 1: Identifying Luggage Compartment Floor

Courtesy of BMW OF NORTH AMERICA, INC.

Removing cross-member

Open welded connections in area (1).

Fig 2: Identifying Welded Connections Area

Courtesy of BMW OF NORTH AMERICA, INC.

Operation is described on the left side. Right side identical.

Open welded connections in the area (1) and remove cross member (2).

Fig 3: Identifying Welded Connections Area And Cross Member

Courtesy of BMW OF NORTH AMERICA, INC.

New part preparation

Open welded connections in area (1) and remove cross member (2).

Fig 4: Identifying Cross Member And Welded Connections Area

Courtesy of BMW OF NORTH AMERICA, INC.

View from below.

Adjust cross member in combination with tail panel to fit and secure.

Set 6 bore holes Ø 4.2 mm for blind rivets N6 in the area (1).

In areas (2) set 3 bore holes Ø 4.2 mm for blind rivets N3 .

Fig 5: Identifying Blind Rivets Bore Holes Area

Courtesy of BMW OF NORTH AMERICA, INC.

Operation is described on the left side. Right side identical.

Set 2 bore holes Ø 4.2 mm for blind rivets N6 in the area (1).

Remove cross member (2) again and deburr bore holes.

Fig 6: Identifying Cross Member And Blind Rivets N6 Area

Courtesy of BMW OF NORTH AMERICA, INC.

Installing cross-member

IMPORTANT: Do not grind new parts and body in area of bonding surfaces.

Clean all bonding surfaces on new part and on vehicle with cleaning agent R1.

Apply adhesive to bonding surfaces.

Install cross member and rivet with blind rivets.

After hardening of the adhesive install 3 EMC SCREWS in the areas shown (1).

Fig 7: Identifying EMC Screws Areas

Courtesy of BMW OF NORTH AMERICA, INC.