66 33 010 Removing and installing/replacing ultrasound sensor for parking assistant

IMPORTANT: Risk of damage!

Repair work in area (1) is not permitted.

REPLACE SIDE WALL .

Fig 1: Identifying Repair Work Area Of Ultrasound Sensor For Parking Assistant

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Example shown on F10:

IMPORTANT: There must be no pressure exerted on PMA sensor surface (1)!

Fig 2: Identifying PMA Sensor Surface

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Remove front left or right side repeater/trim strip. See AUXILIARY DIRECTION INDICATOR and SIDE PANEL TRIM STRIP .

NOTE: Front side panel area all around front auxiliary turn indicator with parking maneuvering assistant sensor must not be damaged due to the measuring accuracy!

IMPORTANT: Risk of damage!

Carefully unlock catches with a suitable tool . Remove parking maneuvering assistant sensor (1) from auxiliary turn indicator (2).

Installation note:

Catches must lock correctly!

Fig 3: Locating Parking Maneuvering Assistant Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Risk of damage!

Decoupling ring must not be crushed.

Installation note:

Moisten decoupling ring (2) prior to fitting with approved anti-friction agent.

Make sure decoupling ring (2) is correctly seated on parking maneuvering assistant sensor (1)!

Fig 4: Identifying Decoupling Ring And Parking Maneuvering Assistant Sensor

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

After installation, check decoupling ring (1) is correctly seated!

Fig 5: Identifying Decoupling Ring

Courtesy of BMW OF NORTH AMERICA, INC.