51 47 072 Removing and installing/replacing finishing strip on rear left or right entrance (outer)

Special tools required:

Lift cover panel (2) up and out at clips (1) using special tool 00 9 317 .

Remove cover (2).

NOTE: Depending on the model, cover panel (2) is secured with a different number of clips (1).

Fig 1: Pulling Cover Panel Using Special Tool (00 9 3170)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

If necessary, remove clips (1) from entrance with a suitable tool.

Replace faulty clamps (1).

Fig 2: Removing Entrance Clamps

Courtesy of BMW OF NORTH AMERICA, INC.