32 00 620 Adjusting rear axle

NOTE: Vehicles with ACC only:

After an adjustment of the rear axle which alters the driving axis, check and set the ADJUSTMENT OF ACC SENSOR .

Necessary preliminary tasks:

NOTE: A camber change always means a toe change as well. The camber must therefore be adjusted first.

Adjusting camber:

Replace nut (1) and apply 5 Nm.

Turn eccentric bolt (2) to adjust camber to setpoint value.

Tighten nut (1).

Tightening torque 33 32 9AZ .

Fig 1: Turning Eccentric Bolt To Adjusting Camber

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting toe:

Replace nut (2) and apply 5 Nm.

Turn eccentric bolt (1) to adjust toe to setpoint value.

Tighten nut (2).

Tightening torque 33 32 7AZ .

Fig 2: Turning Eccentric Bolt To Adjusting Toe

Courtesy of BMW OF NORTH AMERICA, INC.