31 10 010 Removing and installing/replacing reinforcement plate
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Driving without reinforcement plate is not permitted!
Driving without reinforcement plate is not permitted!
NOTE:
Two variants of the reinforcement plate are installed.
Necessary preliminary tasks:
- Remove underbody protection . See FRONT UNDERBODY PROTECTION and REAR UNDERBODY PROTECTION if necessary.
- F23, F33: Remove both bottom reinforcement struts.
Version 1:
Release screws (1).
Remove reinforcement plate (2).
Installation note:
Replace screws (1).
Tightening torque 31 10 4AZ .
Version 2:
Release screws (1).
Remove reinforcement plate (2).
Installation note:
Replace screws (1).
Tightening torque 31 10 4AZ .