61 31 014 Removing and installing/replacing Start/Stop switch

Special tools required:

NOTE: When working on trim panel components, make sure that the sensitive surfaces are not scratched or damaged.

Pry out Start/Stop switch (1) at the marked retaining points using special tool 00 9 325 .

Disconnect associated plug connection and remove Start/Stop switch (1).

Fig 1: Prying Out Start/Stop Switch Using Special Tool (00 9 325)

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Retaining clips (1) on Start/Stop switch (2) must not be bent or damaged.

Fig 2: Start/Stop Switch Retaining Clips

Courtesy of BMW OF NORTH AMERICA, INC.