61 14 005 Removing and installing/replacing distribution box (front)

Special tools required:

WARNING: Observe SAFETY INFORMATION for handling vehicle battery.

Necessary preliminary tasks:

NOTE: Work shown on the F20 by way of example, deviations in detail are possible in other models.

Turn locks (1) 90° counterclockwise.

Unlock catch (3).

Remove cover (2).

Fig 1: Locks, Cover And Catch

Courtesy of BMW OF NORTH AMERICA, INC.

Release latch mechanisms (1) and remove lid (2).

Installation note:

Make sure cover (2) is correctly locked.

Fig 2: Latch Mechanisms And Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Latch mechanisms (1) and gasket (2) on lid (3) must not be damaged or missing.

Make sure gasket (2) is correctly seated in lid (3).

Fig 3: Latch Mechanisms And Gasket On Lid

Courtesy of BMW OF NORTH AMERICA, INC.

Release power distribution box (1) with special tool 00 9 325 from lower section (2) and pull power distribution box (1) upward.

Fig 4: Releasing Power Distribution Box

Courtesy of BMW OF NORTH AMERICA, INC.

Release and disconnect all plug connections in area (1).

Remove power distribution box (2).

Installation note:

Make sure all plug connections are correctly locked.

Fig 5: Power Distribution Box Plug Connections Area

Courtesy of BMW OF NORTH AMERICA, INC.