61 00... Notes on handling optical fibers
IMPORTANT:
To avoid damage when handling optical fibers, comply with the following points:
- The minimum permitted bending radius is 25 mm
- Do not subject optical fibers to compressive and tensile load
- Protect optical fibers against the effects of heat ≥85 °C (e.g. during welding work, drying work with infrared beams or hot air blower)
- Fibre-optic cables are permitted to show only one junction point (bridge), replace fiber-optic cables if necessary
NOTE:
The optical fibers are coloured differently as follows:
Follow notes for processing cables and optical fibers. See 6113... CUTTING OFF, STRIPPING INSULATION AND CUTTING OPTICAL FIBRES TO LENGTH and 6113... CRIMPING OPTICAL FIBRES .
- Green = MOST (M edia O riented S ystems T ransport) optical fiber
- Yellow = ISIS (I ntelligent S afety and I ntegration S ystem) optical fiber
- Orange=repair fiber-optic cables
Follow notes for processing cables and optical fibers. See 6113... CUTTING OFF, STRIPPING INSULATION AND CUTTING OPTICAL FIBRES TO LENGTH and 6113... CRIMPING OPTICAL FIBRES .