66 33 010 Removing and installing/replacing ultrasonic sensors for Parking Maneuvering Assistant
WARNING: This page is about a different car, the 2014 BMW 428i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Partially remove WHEEL ARCH COVER, FRONT LEFT OR RIGHT .
Unfasten plug connection (2) and disconnect.
Unlock latch mechanisms where marked and pull ultrasonic sensor (1) out of bracket (3).
Installation note:
Latch mechanisms must not be damaged!
Make sure ultrasonic sensor is seated securely!