67 62 000 Removing and installing or replacing flat motor for front left or right power window regulator

Necessary preliminary tasks:

Release nuts (1) and screw (2).

Tightening torque: 51 33 2 AZ .

Feed out flat motor (3).

Unlock associated plug connection and disconnect.

Fig 1: Flat Motor Nut And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1).

Tightening torque: 51 33 1 AZ .

Remove flat motor (2).

Replacement:

Remount support (3).

Fig 2: Flat Motor Support And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Diagram similar.

Installation note:

Make sure drive shaft (2) is correctly seated in mounting (1) at power window regulator (3)!

Ensure that the flat motor (2) is assembled without tension.

Fig 3: Power Window Regulator And Drive Shaft Mounting

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

An initialization must be carried out in order to activate anti-trap mechanism.

Read and comply with NOTES on initialization of power window regulator.