51 24 325 Removing And Installing Or Replacing Left Tension Spring For Tailgate

Necessary preliminary tasks:

WARNING: Danger of injury!
Support tailgate in fully opened position with suitable apparatus.

Lever out cover (1) and release screw underneath.

Tightening torque: 51 47 1AZ .

Remove lashing eye (2).

Fig 1: Tailgate Lashing Eye And Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove storage tray (1) in upward direction.

Fig 2: Storage Tray

Courtesy of BMW OF NORTH AMERICA, INC.

Release expanding rivets (1).

Feed out luggage compartment wheel arch panel (2) in rear area but do not completely remove.

If necessary, unlock plug connection for charging socket and disconnect.

Installation note:

Luggage compartment wheel arch panel (2) must fit correctly under tailgate rubber seal (1).

Fig 3: Removing Luggage Compartment Wheel Arch Panel

Courtesy of BMW OF NORTH AMERICA, INC.

Note down position of tension spring (1) at rear holder (2).

WARNING: Wear gloves when detaching tension spring (1).

Detach tension spring (1) from rear holder (2).

Feed out tension spring (1) from hinge (3).

Installation note:

Fig 4: Tailgate Rear Holder, Spring And Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Reattach tension spring (1) to rear holder (2) again in the same position.

Installation note:

Positions (1 to 3) influence the closing force of the tension spring.

If the closing force needs to be changed: Adhere to NOTES ON CLOSING FORCE SETTING .

Fig 5: Tension Spring Position

Courtesy of BMW OF NORTH AMERICA, INC.