51 24 324 Removing And Installing Or Replacing Right Tension Spring For Tailgate

WARNING: Danger of injury!
Support tailgate in fully opened position with suitable apparatus.

Remove flap (1).

Fig 1: Tailgate Flap

Courtesy of BMW OF NORTH AMERICA, INC.

Release clip (1).

Feed out trim panel (2) from edge protection (3).

Make a written record of the position of tension spring (5) on rear holder (4).

WARNING: Wear glove when detaching tension spring (5).

Reach to rear of trim panel (2) and detach tension spring (5) from rear holder (4) and hinge (6).

Installation note:

Trim panel (2) must be fitted correctly under edge protection (3).

Reattach tension spring (5) in same position on rear holder (4).

Fig 2: Rear Trim Panel, Spring, Holder And Hinge

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Positions (1 to 3) influence the closing force of the tension spring.

If the closing force needs to be changed: Observe NOTES ON SETTING CLOSING FORCE !

Fig 3: Tension Spring Position

Courtesy of BMW OF NORTH AMERICA, INC.