34 11 220 Removing and installing/replacing both front brake discs (Brembo)

Special tools required:

34 1 280

Necessary preliminary tasks:

REMOVE WHEELS .
Remove and clean BRAKE PADS .

Check minimum brake disc thickness:

Position special tool 34 1 280 at three measuring points in area (1) and measure.
Compare measuring result and lowest value with SETPOINT VALUE .

If the brake discs are replaced, you must also fit new brake pads.

Brake discs may only be replaced in pairs (on each axle).

Fig 1: Checking Minimum Brake Disc Thickness

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: New brake pads may only be installed if the brake disk thickness is greater than the MINIMUM BRAKE DISC THICKNESS .

Release screws (1), remove brake caliper (2) towards rear and tie up.

Installation note:

Tightening torque: 34 11 2AZ .

Fig 2: Removing Brake Caliper

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: To release brake disc: Do not under any circumstances strike friction ring with a hammer or similar!
If necessary, carefully tap on base of brake disc chamber with a rubber mallet.
Clean contact surface of brake disc at wheel hub thoroughly and remove traces of corrosion.
Unevenness on contact surface may result in distortion of brake disc!

Fig 3: Identifying Brake Disc With Mounting Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Release screw (1) and remove brake disc (2).

Installation note:

Replace screw.

Tightening torque: 34 11 1AZ .

After installation:

Read and comply with notes on BREAKING IN NEW BRAKE DISCS/BRAKE PADS .