63 11 560 Removing and installing (replacing) the headlight driver module

WARNING: FOLLOW INSTRUCTIONS FOR HANDLING BULBS/LIGHT SOURCES (EXTERIOR LIGHTS) !
Disconnect all components from voltage supply before removal.

Necessary preliminary tasks:

NOTE: If the retaining clip (2) is present, the central connector on the headlight cannot be disconnected!

Release screw (1) and remove retaining clip (2) if necessary.

Fig 1: Identifying Retaining Clip And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Headlight is shown removed for purposes of clarity.

If necessary, unlock and disconnect the central connector from the headlight.

Release screws (1).

Pull headlight driver module (2) out of headlight (3).

Fig 2: Identifying Headlight Driver Module Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Gasket (1) must not be damaged and must be installed free from grease.

Fig 3: Identifying Headlight Driver Module Gasket

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Teach in headlight driver module (1) via vehicle diagnosis.