51 12 050 Removing and installing/replacing support for rear bumper panel

Necessary preliminary tasks:

Depending on version:

Unscrew screws (1).
Unlock and disconnect plug connection on Smart Opener control unit and bumper aerial

Loosen the latch mechanisms (2) at reinforcement (3).

Remove reinforcement (3).

Installation note:

Fig 1: Bumper Panel Latch Mechanisms And Catches

Courtesy of BMW OF NORTH AMERICA, INC.

Catches (2) must not be damaged or missing.

If necessary, feed out cable.

Unscrew nuts (1).

Tightening torque: 51 12 1AZ .

Remove support (2).

Fig 2: Bumper Panel Support And Nut

Courtesy of BMW OF NORTH AMERICA, INC.