17 11 035 Removing and installing/renewing fan cowl with electric fan (N55)

Necessary preliminary work :

Automatic only :

Release screw (1).

Tightening torque: 17 10 4AZ .

Pull off transmission oil cooler (2) for automatic transmission in upward direction from fan cowl.

Fig 1: Transmission Oil Cooler Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and pull off connector (1) and unclip cable from fan cowl.

Unlock catch (2).

Release screw (3).

Tightening torque: 17 10 1AZ .

Feed out fan cowl upwards and remove.

Fig 2: Removing Fan Cowl

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note :

Make sure fan cowl (1) and holder (2) are in correct installation position.

Fig 3: Fan Cowl And Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check stored fault messages.
Clear diagnostic fault entries from fault memory.