51 49 000 Removing and installing or replacing trim for rear lid

Necessary preliminary tasks:

Release clamps (1).

Feed out left/right cover (2) in direction of arrow.

Fig 1: Removing Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Version with emergency release:

Detach handle (1) from clip (2).

Unhook Bowden cable (3) from handle (1).

Installation note:

Feed Bowden cable (3) through clip (2) and engage correctly in handle (1).

Fig 2: Identifying Bowden Cable, Handle And Clip

Courtesy of BMW OF NORTH AMERICA, INC.

Release screws (1) and remove handle (2).

Remove warning triangle.

Undo bolts (3) and remove holder (4).

Fig 3: Identifying Holder, Screws, Bolts, And Handle

Courtesy of BMW OF NORTH AMERICA, INC.

Release clips (1).

Remove trim panel (2).

Installation note:

If necessary, replace damaged clips (1).

Fig 4: Identifying Trim Panel Clips

Courtesy of BMW OF NORTH AMERICA, INC.